ambush

Information about ambush

An ambush is a surprise attack from a concealed position on a moving or temporarily halted enemy. An ambush is a long established military tactic in which an ambushing force uses concealment to attack an enemy that passes its position. Ambushers strike from concealed positions such as among dense underbrush or behind hilltops. The tactic is generally used to gather intelligence or to establish control over an area. Ambushes have been used consistently throughout history, from ancient to modern warfare. An ambush predator is an animal who uses similar tactics to capture prey without the difficulty and wasted energy of a chase.

Enlarge picture
German infantry ambushed by US Army France 1944.

Procedure

In modern warfare, an ambush is most often employed by ground troops up to platoon size against enemy targets which may be other ground troops or possibly vehicles. However in some situations especially ones deep behind enemy lines, although the actual attack will be carried out by a platoon, a company sized unit will be deployed to support the attack group, setting up and maintaining a forward patrol harbour from which the attacking force will deploy and to which they will retire after the attack. During ancient warfare, an ambush often might involve thousands of soldiers on a large scale, such as over a mountain pass.

Planning

Ambushes are complex multi-phase operations and are therefore usually planned in some detail. First a suitable killing zone is identified. This is the place where the ambush will be laid. It is generally a place where enemy units are expected to pass, and which gives reasonable cover for the deployment, execution, and extraction phases of the ambush patrol. A path along a wooded valley floor would be a stereotypical example.

Ambush can be described geometrically as
  • Linear, when a number of firing units are equally distant from the linear kill zone.
  • L-shaped, when a short leg of firing units are placed to enfilade the sides of the linear kill zone
  • V-shaped when the firing units are distant from the kill zone at end that the enemy enters, so the firing units lay down band of intersecting and interlocking fire. This ambush is normally triggered only when the enemy is well into the kill zone. The intersecting bands of fire stop any attempt to move out of the kill zone.[1]

Preparation

To be successful an ambush patrol must deploy into the area covertly, ideally under the cover of darkness. The patrol will establish secure and covert positions overlooking the killing zone. Usually, two or more cut off groups will be sent out a short distance from the main ambushing group into similarly covert positions. Their job is twofold; first to give the ambush commander early-warning of the approaching enemy (usually by radio or cellphone), and second, when the ambush is initiated, to prevent any enemies from escaping. Another group will cover the front and rear of the ambush position (blocking force) and thus give all round defence to the ambush patrol.

Care must be taken by the ambush commander to ensure that fire from any weapon cannot inadvertently hit any other friendly unit.

Waiting

Having set the ambush, the next phase is to wait. This could be for a few hours or a few days depending on the tactical and supply situation. It is obviously much harder for an ambush patrol to remain covert and alert if sentry rosters, shelter, sleeping, sanitary arrangements, food and water, have to be considered, so this should be done in a patrol harbour away from the site chosen for the ambush. Ambush patrols will almost always have to be self-sufficient as re-supply would not be possible without compromising their covert position.

Execution

Enlarge picture
Diagram of a Vietcong ambush
The arrival of an enemy in the area should be signalled by one of the cut-off units. This may be done by radio or by some other signal, but the enemy must not detect the signal. If radio silence is necessary the pre-electronic expedient of a cord linking the groups, tugged once or twice as a signal, may be employed. The ambush commander will have given a clear instruction for initiating the ambush. This might be a burst from an automatic weapon, use of an explosive device (such as a Claymore mine or other directonal weapon), or possibly a simple whistle blast. The ambush commander judges when the ambush will be most effective; therefore, giving the signal. Against vehicles, the lead and rear vehicles are the primary targets to keep the targets in the killing zone for as long as possible. Targets are prioritised to rapidly destroy the targets cohesiveness. The order of priorities against an enemy infantry unit is the enemy radio operator (in the past identified by the whip ariel of the backpack radio unit such as the British Army's Clansman system), the enemy's unit commander (a more difficult task today when officers and NCOs are dressed and armed in an identical manner to the rest of the infantry squad), and the platoon or section machine-gunner.

After the firefight has been won, the now compromised ambush patrol must leave the area as soon as it is practical to do so. In hit and run operations, especially against superior numbers and forces, the ambush force will begin disengaging even before the firefight has been won. In the past, accepted protocol was to check bodies for intelligence, take prisoners, and treat any wounded enemy. Once this was accomplished the ambush patrol would leave then exfilitrate the area by a pre-determined route. It is no longer common practice to search the enemy after an ambush but rather to leave the area straight away, as the potential gains are far outweighed by the possibility that the enemy may have a larger force en route or have even arranged an artillery strike on the ambush location while the ambush was being initiated.

If time has allowed the ambush force will have prepared their exit, for example placing land mines to cover their retreat, the members of the force making and following a safe route through the mines. If possible a subsidary ambush may be planned along the exit route to catch pursuing troops, and if available the egress may be covered by mortar or artillery fire.

Surviving an ambush

By definition, the ambush contains the element of total surprise, which means the victims of the ambush have no knowledge of how it has been constructed, or what measures may have been employed to prevent escape. Therefore—and this has been proven by the experience of war—the only sure method of survival is withdrawal from the killing zone "the way you came in". All other routes out of the killing zone may be blocked, and in a very well-planned and well-executed ambush, even the "back door" will have been closed by the time the ambush is sprung. The military doctrines are "to attack the ambush", but this is very likely to have been anticipated by the ones who set the ambush, and often plays into their hands. The value of withdrawal is the preservation of the force to "fight another day", when not so taken by surprise.

The best way to survive an ambush is not to run in to them, in order for this to happen movement must not be predictable in timing or route, avoiding the most obvious routes. Rather than moving at a constant speed and direction, the patrol should vary these, with occassional stops to observe both the route ahead and changes behind. Units should move in such a way that they are close enough together for mutual support but far enough apart that one burst of automatic fire will not take out the entire unit. When on foot if possible the patrol should move in such a way to maximise their firepower, for example the arrowhead and spearhead formation, they should not allow themselves to be skylined. Units on foot should have a point man some way ahead of the main body and if possible a rearguard as well. Those travelling in vehicles follow the same procedures with lead and trailing vehicles ahead and behind the main body of vehicles.

References

1. ^ [1]

See also

External links

Military tactics (Greek: Taktikē, the art of organizing an army) are the collective name for methods for engaging and defeating an enemy in battle. Changes in philosophy and technology over time have been reflected in changes to military tactics.
..... Click the link for more information.
Concealment or hiding is obscuring something from view or rendering it inconspicuous, the opposite of exposure. A military term is CCD: camouflage, concealment and deception (looks the same as the surroundings, can not be seen, looks like something else, respectively); in a
..... Click the link for more information.
Underbrush: subter ramale (commonly referred to as the understory), is any small shrubbery found underneath or near a tree or forest. Though underbrush is commonly thought of as simply the shrubbery in deciduous forests, it can also include shrubbery in place such as the .
..... Click the link for more information.
hill is a landform that extends above the surrounding terrain, in a limited area. Hills often have a distinct summit, although in areas with scarp/dip topography a hill may refer to a particular section of scarp slope without a well-defined summit (e.g. Box Hill).
..... Click the link for more information.


A tactic is a method employed to help achieve a certain goal. Military tactics refers to the study of actions undertaken in warfare, but due to its use describing a broad range of subjects, the term is frequently used in
..... Click the link for more information.
Ancient warfare is war as conducted from the beginnings of recorded history to the end of the ancient period. In Europe, the end of antiquity is often equated with the fall of Rome in 476.
..... Click the link for more information.
Modern warfare involves the widespread use of highly advanced technology. As a term, it is normally taken as referring to conflicts involving one or more first world powers, within the modern electronic era.
..... Click the link for more information.
Ambush predators are carnivorous animals who capture prey by stealth or cunning, not by speed or necessarily by strength. They often are skilled at hiding or camouflage, and may be solitary.
..... Click the link for more information.
platoon is a military unit, typically composed of two to four sections or squads and containing about 30 to 50 soldiers. Platoons are organized into a company, which typically consists of three, four or five platoons.
..... Click the link for more information.
company is a military unit, typically consisting of 75-200 soldiers. Most companies are formed of three to five platoons although the exact number may vary by country, unit type, and structure. Several companies are grouped to form a battalion.
..... Click the link for more information.
pass (also gap, notch, col, saddle, bwlch or bealach) is a lower point that allows easier access through a range. On the route through the range, it is locally the highest point on the route.
..... Click the link for more information.


Enfilade and defilade are concepts in military tactics used to describe a military formation's exposure to enemy fire.
..... Click the link for more information.
All round defence is a defensive posture, usually adopted in times of confusion by all military units from squad up. In a prepared position, all round defence is adopted so that the unit is capable of observing all ground and directing fire onto the observed ground.
..... Click the link for more information.
radio silence is a status in which all fixed or mobile radio stations in an area stop transmitting. The radio stations include anything capable of transmitting a radio signal.
..... Click the link for more information.
weapon is a tool used to injure, incapacitate, or kill an adversary.[1][2] Weapons may be used to attack and defend, and consequently also to threaten or protect. Metaphorically, anything used to damage (even psychologically) can be referred to as a weapon.
..... Click the link for more information.
M18A1 Claymore is a directional anti-personnel mine used by the U.S. military. It was named after the large Scottish sword by its inventor, Norman A. MacLeod. The Claymore fires shrapnel, in the form of steel balls, out to about 100 meters across a 60° arc in front of the device.
..... Click the link for more information.
Generally, a battle is a specific instance of combat in warfare between two or more parties wherein each group will seek to defeat the others. Battles are most often fought during wars or military campaigns and can usually be well defined in time, space and action.
..... Click the link for more information.
land mine is an explosive device designed to be placed on or in the ground to explode when triggered by an operator or the proximity of a vehicle, person or animal. The name originates from the practice of sapping, where tunnels were dug (much like mining) under enemy
..... Click the link for more information.
sniper is an infantry soldier who specializes in shooting from a concealed position over longer ranges than regular infantry, often with a specially designed or adapted sniper rifle. It requires skill in marksmanship, camouflage and field craft.
..... Click the link for more information.
This page contains a list of military tactics:

Principles

  • Identification of objectives
  • Concentration of effort
  • Exploiting prevailing weather
  • Exploiting night
  • Maintenance of reserves
  • Economy of force

..... Click the link for more information.
flanking maneuver, also called a attack, is an attack on the sides (flanks) of an opposing force. If a flanking maneuver succeeds, the defending force is attacked from two or more directions, which significantly reduces its ability to defend itself.
..... Click the link for more information.

This article is copied from an article on Wikipedia.org - the free encyclopedia created and edited by online user community. The text was not checked or edited by anyone on our staff. Although the vast majority of the wikipedia encyclopedia articles provide accurate and timely information please do not assume the accuracy of any particular article. This article is distributed under the terms of GNU Free Documentation License.